New Museum Project - Trade Package: Partitions, Drylining and Ceilings (General Market)

These Trade Contract Works shall comprise the planning, sequencing, management, Trade-Contractor Design including connections, coordination, project specific method statements, technical submittals, surveys, risk assessments, procurement, manufacturing, delivery, offloading, storage, distribution, setting out, positioning, installing, and handover of the complete Drylining, partitions and ceilings including, but not limited to:

1.Provision to allow installation of flush skirting with shadow gap beads to be incorporated into fire / acoustic rated partitions.

2.Angle reinforcements behind boards at re-entrant corners.

3.Install fire / acoustic seals.

4.Allow for DPC installation under partitions according to construction information.

5.Cavity insulation

6.Structural movement joints

7.Sealant: Gyproc FireStrip, soft extruded intumescent gap sealer

8.Continuous beads of acoustic sealant, fire rated where required, around the perimeter of the framing or to the outer edges of the board, ensuring all air paths are sealed.

9.In shaft walls the core board is to be bedded onto continuous beads of fire rated sealant and board joints of the outer layer to be sealed to the inner layer with continuous beads of fire rated sealant.

10.Removal of any COSHH waste.

11.All access for the works.

12.All horizontal movement of materials.

13.Comply with required recycled content.

14.Making good around cut-outs made by MEPH contractors.

15.Strengthening studs around door openings and wherever necessary.

16.Form box outs around building services.

17.Construct all necessary bulkheads in all types of ceilings.

18.Form openings in both partitions and suspended ceilings for access panels, grilles and the like including any structural supports that may be required.

19.Form all necessary openings for building services penetrations (e.g. pipework, ductwork, cables etc.) including all necessary secondary steelwork/support work.

20.Provide and install all necessary structural support, noggins and pattresses within the stud partitions and ceilings to support building services, fixtures, fittings and signage.

21.Make good using acoustic and/or fire stopping around service penetrations and at interfaces with other elements up to 150mm in width.

22.All insulation to ensure the fire and acoustic performance is achieved in line with the specifications.

23.All abutments, angles, junctions, and fair ends.

24.All acoustic and non-acoustic deflection head details.

25.Allowing for reduced stud centres where required.